Gingersnap Pumpkin Cheesecake
Ingredients
- For the gingersnap crust:
- 2 cups gingersnap cookies, crumbled
- 4 tablespoons butter, melted
- ¼ cup dark brown sugar
- For the Pumpkin Cheesecake Filling
- 3 (8-ounce packages) cream cheese, room temperature
- 1 cup granulated sugar
- ⅓ cup sour cream
- 4 large eggs, room temperature
- 1 cup pumpkin puree
- 1 teaspoon ground cinnamon
- ½ teaspoon ground ginger
- ¼ teaspoon ground cloves
- ⅛ teaspoon ground nutmeg
- 1 teaspoon of vanilla
- For the Buttery Streusel
- ¼ cup brown sugar
- ½ cup all purpose flour
- 4 tablespoons cold unsalted butter cut into pieces
- * caramel sauce - optional
Instructions
⇆
Instructions
- Preheat oven to 325°F.
- Begin by wrapping a 8 or 9-inch springform pan with aluminum foil, (set the springform pan in the middle and fold the edges of the foil up around the sides of the pan).
- The foil gives you extra protection against water getting into the pan during the water bath step.
- Generously butter the inside of a springform pan, or spray the pan with nonstick cooking spray.
- Combine crushed gingersnap cookies, melted butter and dark brown sugar in bowl until completely combined.
- Press onto bottom of springform pan.
- Bake for 10 minutes in the preheated oven.
- Remove from oven and let cool completely while you prepare the filling.
- In a separate bowl, stir to combine the sugar, cinnamon, ginger, cloves and nutmeg.
- In the bowl of a standing mixer beat the cream cheese on medium speed just until it is lump free and smooth.
- Beat in sour cream, and gradually add the sugar mixture and beat until creamy and smooth (1 to 2 minutes).
- Add the eggs, one at a time, beating well (about 30 seconds) after each addition.
- Scrape down the sides of the bowl and beat in the vanilla and pumpkin puree.
- It’s important not to overmix — if you incorporate too much air into the filling, it will rise and crack or fall when it bakes.
- Pour mixture onto gingersnap crust.
- In another bowl combine flour and brown sugar. Using a pastry cutter cut cold butter into the mixture until crumbly.
- Sprinkle mixture over the top of the cheesecake mixture.
- Place springform pan in a roasting pan large enough to prevent the sides from touching.
- Bring a few cups of water to a boil and pour the water into the roasting pan, being careful not to splash any water onto the cheesecake.
- Fill the pan to reach halfway up the sides of the springform pan.
- Bake in a 325 degree oven about 1 to 1-1/2 hours, rotating once halfway through, until cheesecake just set around the edges and a toothpick inserted in the center emerges clean.
- I used 8 inch springform pan so I had to bake the cake almost 1 hour 30 minutes to set.
- Turn off the oven and crack the door open. Let the cheesecake cool slowly for two to three hours.
- Remove aluminum foil and refrigerate (at least 5 hour or overnight).
- Do not try to remove the cheesecake from the pan until it has set up in the refrigerator overnight or at least 5 hours.
- This step is crucial for letting the cheesecake set and achieving perfect cheesecake texture — don't rush it.
- Unmold the cake (run a thin knife around the edge and take of the ring of springform pan) and top the cheesecake just before serving.
- You can either serve the cake right from the bottom of the springform pan or garnish with caramel sauce.
- It’s a good idea to bake this cake a day ahead of time or early in the morning on the day you plan to serve it.
0 comments :
Post a Comment